roland.meier3

How To Manage Compliance Exclusions in Snow License Manager 9.0.1

Blog Post created by roland.meier3 Employee on Mar 27, 2019

Background: you want to exclude specific software installations on specific computers from the compliance calculation in your Snow License Manager. This could have multiple reasons and has been solved in different ways in the past and/or still for some special cases.

 

Previous challenges and solution:
Examples:
MSDN: licensing of multiple test systems, where only specific Microsoft products could be covered.
OEM licenses connected to the relevant hardware.
Terminal servers: some software manufacturers, including Microsoft, allow their software to be installed on terminal servers, but these are not counted towards a compliance, rather the devices under TS- applications.
Training environments: some software manufacturers, including Microsoft, give the right to use a limited number of computers with their software for free under certain agreements.
All other software products that might cover more than two installations where there might be no direct technical linkages to secondary use rights or other use rights.
Solution:
The main solution is implemented by moving the relevant computers to a dummy organizational unit, and then adding dummy site licenses to these to cover all of the relevant software installations.

 

The following example will show how one software application will be removed from the compliance calculation in Snow License Manager.


Step 1: find the application that needs to be adjusted and check the current compliance. 

 

Step 2: if you have administrative rights in Snow, go to the “Administration” page and click on “Compliance exclusions”.
 

Step 3: click on “Add exclusion” to start defining the compliance exclusions.
 

 

Step 4: enter the rule name and reason. The “Active” checkbox can only be used later or set in the last step.
 

Step 5: search for the identified application as in Step 1 and mark the checkbox to fill the right-side column. In this right-side column you can delete wrong applications by clicking on the small cross or “Clear list”.
 

Step 6: search for the computers or use the “Filter with installations” functionality. Mark the required computers in the results list and you can delete computers from the right-side column by clicking on the small cross or remove all with “Clear list”.
 

Step 7: after these steps please click “Save” at the bottom right side of the window.
 

 

Step 8: as mentioned in Step 4, you are asked if your settings should be activated. If your settings are correct, please click on “Yes” to activate the rule.
 

Step 9: your rule will then be added to the list of all rules and can be edited from here in future or deleted by clicking the small cross on the right side of each rule. More rules can be added here by clicking on “Add exclusion”.
 

Step 10: after adding/editing any rule, please ensure that you start a compliance recalculation before looking for any changes. This menu item can be found under your user name in the top right hand corner.
 

 

Step 11: open the application(s) that you are working on and see how many computers have been manually excluded from the compliance calculation.
 

Please note that this is a new feature and might change over time.

Outcomes